Job site storage - intended for interior use only - store off the ground & cover to protect from water and allow for ventilation.
During construction if the wood should become wet it should be allowed to dry before being covered or enclosed.
Do not burn preserved wood.
Wear a dust mask and goggles when cutting or sanding wood.
Wear gloves when working with wood.
Do not use preserved wood as mulch.
Some preservative may migrate from the treated wood or may dislodge from the treated wood surface upon contact with skin. Wash exposed skin areas thoroughly.
Fasteners and other hardware must be compliant with building codes.
Disposal Recommendations - Preserved wood may be disposed of in landfills or burned in commercial or industrial incinerators or boilers in accordance with federal, state and local regulations.
Mould growth can and does occur on the surface of many products, including untreated and treated wood, during prolonged surface exposure to excessive moisture conditions. To remove mould from the treated wood surface, wood should be allowed to dry. Typically, mild soap and water can be used to remove remaining surface mould. For more information visit www.epa.gov.
When products are used in weather protected exterior applications (such as fascia board), it is recommended that the product be continuously protected from direct wetting with a minimum of one coat oil-based primer and two coats oil-based finish paint/sealer. Always check the label of the finishing product and follow the manufacturer’s instructions. During construction, if the wood should become wet it should be allowed to dry before finishing. Apply finishing product to a small exposed area of your project before finishing the entire project.
